ADG Clock thermostat for electrical underfloor heating where optimum comfort temperature and minimum energy consumption are required.

Programmable Thermostats with built-in 15 mA EGFPD

An “all-in-one” programmable thermostats for electric underfloor heating control where optimal comfort temperature and minimum energy consumption is required.



  • Simple user interface and thoughtfulinstallation design
  • Pre-programmed for quick set-up
  • Monitored energy consumption
  • Simple operation - no need for manual
  • Multi voltage: 120 - 240 V (incl. 208 V)
  • Output relay: 15 A
  • Large back-lit display for easy reading
  • Single thermostat for all applications (room, floor, room with floor limititation and as regulator)
  • Industrial Design:
    USA - Design Patent No. D768092
    Canada - Design Patent No. 161353
  • What is the backup time?


    The program settings are permanent, the clock will be reset after 2 to 4 hours.

  • How to unlock the child lock?


    • From the home screen

    • Press "OK" button twice

    • Press button UP and DOWN simultaneously for 3 sec.

    • Unlock Child Lock (MP4)

  • What does error code "E2" mean?


    Error code "E2" means defective, damaged or not connected floor sensor. Check connections or replace sensor if necessary.

  • What causes the led to be permantly ON?


    Your heat mat or installation between thermostat and heat mat has a fault current to ground. The thermostat has cut off the power for your safety. Please contact your local electrician.

  • How to make the USG switch off when the thermostat does?


    Check the connections between the two units. If the USG is connected incorrectly to the thermostat, the USG won't switch off.

  • Where to connect the ground wire of floor mats?


    The ground wire in the floor mat must be connected directly to the ground wire of the supply.

  • What is the recommended night setback?


    The recommended night setback is max 5°C/41°F



  • Does the adaptive function reset when making a factory reset?


    Yes the adaptive function is reset during a factory reset.



  • What is the maximum length of the sensor cable?


    In general, we recommend a maximum cable length of 50 meters, the length might be shorter. Read the instructions for the precise maximum length.

  • How can I cure the E2 error message?


    "E2" means defective, damaged or disconnected floor sensor. Sensor resistance should be 10 or 12 kOhm at 25°C (77°F). The onstruction or quick guide holds informatiom for the specific thermostats.

Our Brand

Know How Creates
Know How Creates

Know How Creates is our promise to you: we use our insight and expertise to find the right solution.


Floor Heating Electric

Find the latest Floor Heating Electric News from OJ Electronics here.

Green Comfort

Intelligent Control
Green Comfort

Intelligent control results in maximum comfort with low energy consumption.


OJ Electronics
Contact OJ Electronics

Dialogue and close cooperation is the shortest way to a perfect solution.