ACG (Discontinued)

ACG Clock thermostat for electrical underfloor heating where optimum comfort temperature and minimum energy consumption are required.

Programmable Thermostats with built-in 15 mA EGFPD

OJ Microline® ADG

An “all-in-one” programmable thermostats for electric underfloor heating control where optimal comfort temperature and minimum energy consumption is required.

EFFICIENT, INTUITIVE AND STYLISH

*Industrial Design:   
USA - Design Patent No. D633445
Canada - Design Patent No. D130878

  • Simple user interface and thoughtfulinstallation design
  • Pre-programmed for quick set-up
  • Monitored energy consumption
  • Simple operation - no need for manual
  • Multi voltage: 120 - 240 V (incl. 208 V)
  • Output relay: 15 A
  • Large back-lit display for easy reading
Related
Products
FAQ
  • What is the backup time?

    Reply

    The program settings are permanent, the clock will be reset after 2 to 4 hours.

  • How do I unlock the child lock?

    Reply

    • Exit all menu's


       
    • Press "OK" button once

    • Press button UP and DOWN simultaneously for 3 sec.

  • What does error code "E2" mean?

    Reply

    Error code "E2" means defective or not connected floor sensor. Check connections and replace sensor if necessary.

  • What causes the led to be permantly ON?

    Reply

    Your heat mat or installation between thermostat and heat mat has a fault current to ground. The thermostat has cut off the power for your safety. Please contact your local electrician.

  • What is the recommended night setback?

    Reply

    The recommended night setback is max 5°C/9°F

     

     

  • Does the adaptive function reset when making a factory reset?

    Reply

    Yes the adaptive function is reset during a factory reset.

     

     

  • How to make the USG switch off when the thermostat does?

    Reply

    Check the connections between the two units. If the USG is connected incorrectly to the thermostat, the USG won't switch off.

  • Where to connect the ground wire of floor mats?

    Reply

    The ground wire in the floor mat must be connected directly to the ground wire of the supply.

  • What is the maximum lenght of the sensor cable?

    Reply

    In general, we recommend a maximum cable length of 50 meters.

  • E2 - How can I cure this error message?

    Reply

    "E2" means defective or disconnected floor sensor. Sensor resistance should be 12kOhm at 25°C (72°F).

Our Brand

Know How Creates
Know How Creates

Know How Creates is our promise to you: we use our insight and expertise to find the right solution.

News

Floor Heating Electric
FHEL News

Find the latest Floor Heating Electric News from OJ Electronics here.

Green Comfort

Intelligent Control
Green Comfort

Intelligent control results in maximum comfort with low energy consumption.

Contact

OJ Electronics
Contact OJ Electronics

Dialogue and close cooperation is the shortest way to a perfect solution.